Grove – Multichannel Gas sensor is a environment detecting sensor with a built in MiCS-6814 which can detect many unhealthful gases, and three gases can be measured simultaneously due to its three channels, so it can help you to monitor the concentration which more than one gas.
This sensor is belong to Grove system, and you can plug it onto the Base shield and work with Arduino directly without any jumper wires. The interface of it is I2C, so plug it onto the I2C port of Base shield, then you can start to work it.
Three fully independent sensing elements on one package
Built with ATmega168PA
I2C interface with programmable address
Heating power can be shut down for low power
Detectable gases:Carbon monoxide (CO) , Nitrogen dioxide (NO2) , Hydrogen (H2) , Ammonia (NH3) , Methane (CH4) , etc.
Voltage: 3.1~ 5.25V
Max Heating Power: 88mW
Max Power: 150mW
ADC Precision : 10Bits
I2C Rate: 100kHz
1 x Grove – Multichannel Gas Sensor
1 x 26AWG Grove Cable
Please visit our wiki page for more info about this product. It will be appreciated if you can help us improve the documents, add more demo code or tutorials. For technical support, please post your questions to our forum.
It can be used with raspberry pi along with grovepi.There is a software available for multichannel gas sensor to use with grove pi in the following link https://github.com/DexterInd/GrovePi/tree/master/Software/Python/grove_i2c_multichannel_gas_sensor
Please kindly guide how to measure all 6 gasses through this sensor. Code example is for 3 gasses only.
Hi.I'm very appreciated for your attention,and i'm very sorry for that mistake.We will solve this problem ASAP,after that,we would keep in touch with you.Thanks again.
Free shipping on your first order over $50 or more. Discounted items included!