Bus Pirate v3.6 universal serial interface

SKU 102990038

Free Express Shipping on Orders over $200!



Bus Pirate v3 is a universal bus interface that talks to electronics from a PC serial terminal. Get to know a chip without writing code. Eliminates a ton of early prototyping effort with new or unknown chips. A laser cut acrylic case for Bus Pirate v3.6 is also available.

This board provides 1-Wire, I2C, SPI, JTAG, asynchronous serial (UART), MIDI, PC keyboard, HD44780 LCDs, and generic 2- and 3-wire libraries for custom protocols.


  • • USB interface, USB powered
  • • 5 volt tolerant pins-0-6volt measurement probe
  • • 1Hz-40MHz frequency measurement
  • • 1kHz-4MHz pulse-width modulator, frequency generator
  • • On-board multi-voltage pull-up resistors
  • • On-board 3.3volt and 5volt power supplies with software reset
  • • Macros for common operations
  • • Bus traffic sniffers (SPI, I2C)
  • • Transparent USB to serial bridge mode
  • • 10Hz-1MHz low-speed logic analyzer
  • • Custom support in AVRDUDE, Flashrom, OpenOCD
  • • AVR STK500 v2 programmer clone
  • • Scriptable from Perl, Python, etc.
  • • A bootloader for easy USB firmware updates
  • • Uses DP6037 standard PCB layout
  • • Open source (CC 0/Public Domain)


If you encounter any problems when using this product, here is the forum from which you can get the technical support.


Bus Pirate v4Bus Blaster v3Bus Blaster v4Bus Pirate v3 probe Kit
You Might Also Need

Bus Pirate v3.6 universal serial interface

Free Express Shipping on Orders over $200!

  • $27.15 /each 1 pcs
  • $24.44 /each 10 pcs
  • $23.08 /each 20 pcs
  • $21.72 /each 50 pcs
Notify me when it's back in stock