IoTea LoRa SmartAgriculture
PM2.5 PollutionVisualization WioLTE
The Grove - Light Sensor v1.2 is an analog module and can output various electrical signals which can be converted to different ranges. It integrates LS06-S photoresistor, a high-sensitive and reliable photodiode, to detect the intensity of light in the environment. It is a perfect Arduino light sensor module for light measurement, light detection, and light-controlled switch.
Who Viewed This Also Viewed
For all Grove users (especially beginners), we provide you guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before you use this product.
Easy to use: Interfaced with Grove port, just plug-and-play
Higher reliability and sensibility compared with Grove light sensor 1.0
Short response time: 20 ~ 30 milliseconds
Recognize wider spectrum
As an updated version of Grove - Light Sensor 1.0, the Grove - Light Sensor v1.2 is an analog module and can output various electrical signals which can be converted to different ranges (It depends on the Analog-to-Digital-Converter on your controller board. For example, it can output 0-255 for an 8-bit ADC). It is a perfect LDR sensor module for light measurement, light detection, and light-controlled switch.
Compared with Grove - Light Sensor 1.0, the Grove - Light Sensor v1.2 is also aimed at measuring light levels, however with higher reliability and sensibility. It replaced the traditional LDR GL5528(light dependent resistor) with LS06-S photoresistor, a high-sensitive and reliable photodiode, to detect the intensity of light in the environment. The resistance of photoresistor decreases when the intensity of light increases. Also, a dual OpAmp chip LM358 on board produces a voltage corresponding to the intensity of light(i.e based on resistance value). The output signal from this module will be HIGH in bright light and LOW in the dark.
And just like other grove modules, it is interfaced with Grove port which can save you a lot of work in the wiring. It will be a perfect choice if you are looking for a plug-and-play Arduino light sensor apart from the traditional LDR Arduino sensor and Arduino photocell sensor.
This is the wiki page for this product, which will show you how to use the product, as well as details about the software and hardware.
A cube with all the necessary sensors, suitable for a wide range of applications like agriculture, monitoring, ,etc.
I would like to share my first steps with the Grove 'plug & play' components. This is primarily a Light Sensor.
En esta lección vamos a aprender a conectar y programar el módulo sensor de luz de GROVE.Thanks Javier Martinez provide this lesson for introduction to Seeeduino with Grove Starter Kit.
In this lesson you will learn how to connect and program the light sensor grove module.Thanks Javier Martinez provide this lesson for introduction to Seeeduino with Grove Starter Kit.
The Grove - Light sensor integrates a photo-resistor(light dependent resistor) to detect the intensity of light. The resistance of photo-resistor decreases when the intensity of light increases. A dual OpAmp chip LM358 on board produces voltage correspond
Hi Scott, It is available now. We feel your pain, the in stock notification function will be available soon. Regards
Hi, I've bought this sensor. I'm reading the analog values of the sensor and the max read is 738. Is it possible to have a table where you map analog values with lux? Because at the following link http://wiki.seeedstudio.com/Grove-Digital_Light_Sensor/ I did not find anything about it