Thank you for your feedback!
We will cherish every piece of your feedback and respond as fast as we can if necessary.
Once your suggestion gets adopted, an equal value coupon will be sent to thank you.
Ever wanted a development kit that flies? Well now you can! The Crazyflie is an open source nano quadcopter kit designed for flexible development and hacking. It's among the smallest in the world, weighing only 19 grams and measuring 9 cm motor to motor.
The development platform is open source so schematics and firmware/host source code is available at the Bitcraze website as well as a Wiki with design information and details on how to set up the development environment and get started. It’s designed with development in mind and has an expansion header that enables developers to expand the platform as well as good software development support. Due to it’s small size it’s perfect for developing new software and can easily be flown inside. It can lift a payload of up to 5 - 10 g.
This is the 10 DOF version of Crazyflie that integrate extra sensors for altitude and heading measurement. There is yet no firmware support for these sensors but they have the potential to enable heading and altitude control. If you want to develop a new algorithm or if you want to be able to use some advanced algorithm that might be created for these sensor you should definitely consider the 10-DOF version.
A 2.4 GHz radio chip from Nordic Semiconductors is used for receiving commands and sending telemetry data back to the host computer. The communication with the host is made possible by using the Crazyradio 2.4 GHz USB radio dongle. The Crazyradio can be connected to a PC (with support for Windows and Linux) but also to other hosts that support USB Host or OTG like Android phones.
The Crazyflie Quadcopter is shipped pre-programmed and can easily be wirelessly updated via a radio bootloader from a host PC, so no JTAG is required for reprogramming. For advanced development and debugging there’s also an accessible JTAG interface.
This kit requires soldering skills and is not for beginners. It is not a toy and should be handled with care.
Crazyflie features
Small and lightweight, around 19g and about 90mm motor to motor
Flight time up to 7 minutes with standard 170mAh Li-Po battery
Standard micro-USB connector for charging which takes ~20min for the stock 170mAh Li-Po battery
On-board low-energy radio@1mW based on the nRF24L01+ chip. Up to 80m range (environment dependent) when using the Crazyradio USB dongle
Radio bootloader which enabled wireless update of the firmware
Each part of the Crazyflie Nano Quadcopter Kit is tested before it leaves the factory, but please keep in mind that kit is still experimental, unproven hardware. This hardware is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.
The camera of the Rpi was released last week,look here:
http://www.raspberrypi.org/archives/3890
is the connector of this quadcopter suitable for this camera?
(it's 3 grams weight).
Apparently it was restocked yesterday, but u wasn't notified of that, i have been tracking this product for a long time, when is there going to be more stock and yes i had added my email to the notify me
Bad experience. Unable to get the USB dongle working. Posting question(s) in the forum just triggered canned suggestions about USB3 vs USB2. Looks like a nice toy to play with, if it one can get it to work. Wasted my money on this and would not recommend it.
0 items
