IoTea LoRa SmartAgriculture
PM2.5 PollutionVisualization WioLTE
Who Viewed This Also Viewed
This is a pressure measuring sensor. You can use it in clean, non-corrosive gas and liquid.
Compact, Easy to Install
High Sealing Performance
High Quality Hall Effect Sensor
Wokring Voltage(VCC): DC 5±0.5V
Working Current: ≤10mA (DC 5V)
Output Voltage(Vout): DC 0.5~4.5V
Vout = VCC x (0.75 x P + 0.1), P is Pressure.
Working Pressure Rate Range: 0~1.2Mpa
Max. Pressure: 2.4Mpa
Destructive pressure: 3.0Mpa
Working Temperature: -20～+ 105℃
Storage Temperature: -20～+ 105℃
Measurement Accuracy: ±1.5%FS
Response Time: ≤2.0ms
Cycle Life: 1,000,000 pcs
1 x Water Pressure Sensor
Yes, you can connect the 5v to red wire, gnd to black wire and arduino analog port to yellow wire. Then you can use the analog port to get the yellow cable voltage reading and the follow the formula to convert to pressure, P=(Vout/5-0.1)*4/3, unit is MPa. thanks.
Hi there, NO, we do not have the calibration for temperature. By the way, the working temperature is 0~65 degree C. thanks.
Hi there~ Yes the cable is included. And the body is made by Carbon steel.Regards
Hi there~ We made a waterproof treatment for the electronic part in IP65 level. Sorry we do not have a datasheet.
Hi Eoin~ Yes you can, three jumper will be ok.
Hi David~ This is standerd British G1/4 thread
From the image, it is G1/4 (British tread)