Note：This product will be EOL soon, please consider the Grove - OLED Display 1.12'' V2 as alternative choice.
Grove - OLED 1.12'' is a 16 color grayscale 96×96 dot matrix OLED display module with Grove compatible 4pin I2C interface.Grove - OLED 1.12"is constructed with 96 x 96 dot matrix OLED module ([ LY120])and SSD1327 driver IC. The characteristics of this display module are high brightness, self-emission, high contrast ratio, slim / thin outline, wide viewing angle, wide temperature range, and low power consumption.
Dot Matrix: 96 x 96 Pixels
Color: Grayscale Display (16 Gray shades)
Supports both Normal and Inverse Color Display
Supports Continuous Horizontal Scrolling
Grove compatible 4pin I2C connector
Works with both 5V and 3.3V logic MCUs
Wide range of operating temperature: -40 °C ~ 70 °C
Graphic display adapter for Seeeduino and Arduino using Grove stem board
Display adapter for any 5V or 3.3V MCU which supports I2C interface
Can be used with mbed microcontroller
For all Grove users (especially beginners), we provide you guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before your using of the product.
Please visit our wiki page for more info about this product.
It will be appreciated if you can help us improve the documents, add more demo code or tutorials. For technical support, please post your questions to our forum.
|Dimensions||40mm x 40mm x 10mm|
|Grove - OLED Display 1.12''||1|
I have just ported the supplied Arduino library over to mbed and published it here: http://developer.mbed.org/user... . This display is a little
When trying to download schematics for this module from wiki, I get nothing. The link I am trying to use is: http://www.seeedstudio.com/wik...
With the 1.12"OLED Display it is possible to print Float Numbers using the command SeeedOled.putFloat(), but in this screen the only command available is .putNumber()!
How do I print float type numbers in this display?!
The method SeeedGrayOled.clearDisplay() do nothing on my code.
I write on the screen but when i call clearDisplay nothing happens.
I'm using UNO R3.
Can it show images in 16 shades of gray? Already use this one, see text in shades in sample code, but no such code for images.
I'm using Seeedino Stalker v2.2 and Grove - Base shield. I connected this OLED into the first I2C slot. It was looking OK just before pulsing my G1/2 Water Flow Sensor with digital pin 2 (interrupt 0). So I changed the pin of G1/2 Water Flow sensor fro
When do you think you will be able to update the library so that these OLEDs would work with Arduino IDE 1.0?
I wanted to use my oled with a big sketch I did in v.1.0 so it would be hell to change it to v.0.23.
Waiting impatiently for an an
The files are ok, can be downloaded and included, but something is wrong. I cannot run the examples on my"Romeo ALL in one controller"
I hope to be able to run the module.
Next files are corrupted, please reload it on this web site. http://www.seeedstudio.com/dep...
It's for the 'Grove - OLED 96x96'.
I'm not able to download the 'Seeed Gray OLED library' zip file, it's always corrupted. Could you see that it work, please?
Free shipping on your first order over $50 or more. Discounted items included!